MANUAL TEST STATIONS

• 2 Precision Calibrated Mass Flow Controller
  Key pad programmed for a wide range of gases
  Digital Flow Rate Display (sccm)
  1000 sccm capacity
• 2 Back Pressure Regulators 0-60 psi
  Analog Pressure Display (psi)
• 1 Temperature Controller
  Precision PID algorithm
  330 Watt AC output
• Solid State Electronic Load ECL 150
  400 W max, 20 V max, 20 Amp max

Specifications
Pressure	Maximum Backpressure 60 psig (ca. 5,2 Bar)
Digital Fluid Flow Display	4 digit display, minimum resolution 1 sccmFlow Accuracy, 1,5% of Full Scale
Digital Fluid Flow Display	4 digit display, minimum resolution 1 sccm Flow Accuracy, 1,5% of Full Scale
Fluid Connections	1/4” Swagelok™ Tubing Connectors Front Panel Output to Fuel Cell (2) Return from Fuel Cell (2) Rear PanelInput Reactant Gases (2) Vent of Reactant Gases (2)
Electrical Accessories	Type K Thermocouple2 prong AC Heater Cord
Temperature Controller	Front Panel Readout and Control 330 W PID Controller (AC)
Physical Characteristics	19” W x 5.25” H x 13” D (48 cm x 14 cm x 33 cm) 20 lbs. (9 kg)
Electrical Requirements	110 VAC 5A (or 220 VAC 2,5A)

MTS 150-DM adds direct methanol capabilities to the MTS test station. The MTS-150-DM includes the methanol pump with flow rates from 2.6 up to 100mL/min (higher rates available on request).

The MTS 150-HGL contains two heated gas lines, which provide a non-condensing condition between the humidifier and the cell being tested.

Typical MTS-150™ Configuration with HSA-TC™ and ECL-150™